Installation Manual
ManualsBrandsHestan ManualsBuilt-In Dishwashers24 Inch Fully Integrated Built-In Dishwasher with 13 Place Settings, 10 Wash Cycles, Full-Sized 3rd Rack, 42 dBA Quiet Operation, Double Axial Washing System™, AquaLeak Detection Technology™, Marquise Accented™ Handle, Auto Door-Open Drying, Interior Ligh
Table Of Contents
- PRÉCAUTIONS DE SÉCURITÉ - AVANT DE COMMENCER
- NUMÉROS DE MODÈLE
- PLAQUE SIGNALÉTIQUE
- RESPECT DE LA RÉGLEMENTATION ET DES CODES EN VIGUEUR
- AVERTISSEMENTS SUR LES PRODUITS / SECURITE
- EMPLACEMENT ET PREPARATION
- INSTALLATION
- PRÉPARATION DES PANNEAUX DÉCORATIFS
- ÉTAPES FINALES
- SERVICE
- SAFETY PRECAUTIONS - BEFORE YOU BEGIN
- MODEL NUMBERS
- RATING LABEL
- REGULATORY / CODE REQUIREMENTS
- PRODUCT WARNINGS / SAFETY
- LOCATION AND PREPARATION
- INSTALLATION
- OVERLAY PANEL
- FINAL STEPS
- SERVICE
OVERLAY PANEL
(MODEL KDW24-OV)
OVERLAY PANEL PREPARATION OVERLAY PANEL PREPARATION
MOUNTING SUPPORT HOOKS AND BRACKETSMOUNTING SUPPORT HOOKS AND BRACKETS
1. Place the provided template on the inner surface of the overlay panel.
2. Center the template on the panel and align it with the top edge, matching up the reference
locators (A).
3. Mark the position of the door hooks and brackets
with a pencil.
4. Remove the template and use a drill with a suitable
bit to make pilot holes at the points marked on the
panel.
• To avoid drilling too deep, use of a drill stop is
recommended.
5. Using a Phillips screwdriver, secure the door hooks (B, C) with the 8 supplied flat head screws
(items F) at the marked reference points.
6. Use the screwdriver to secure the lower
brackets (D, E) with the 8 supplied round
head screws (item G) at the marked
reference points.
OVERLAY PANEL DIMENSIONS:
WIDTH: 23-7/16" [596 mm]
HEIGHT: 31-7/8" [810 mm] MAX
THICK: 3/4" - 1-3/16" [19 - 28 mm]
WEIGHT: 5-22 lbs. [2.5 - 10 kg]
A
A
©2021 Hestan Commercial Corporation
14
EN