Installation Manual
ManualsBrandsHestan ManualsBuilt-In Dishwashers24 Inch Fully Integrated Built-In Dishwasher with 13 Place Settings, 10 Wash Cycles, Full-Sized 3rd Rack, 42 dBA Quiet Operation, Double Axial Washing System™, AquaLeak Detection Technology™, Marquise Accented™ Handle, Auto Door-Open Drying, Interior Ligh
Table Of Contents
- PRÉCAUTIONS DE SÉCURITÉ - AVANT DE COMMENCER
- NUMÉROS DE MODÈLE
- PLAQUE SIGNALÉTIQUE
- RESPECT DE LA RÉGLEMENTATION ET DES CODES EN VIGUEUR
- AVERTISSEMENTS SUR LES PRODUITS / SECURITE
- EMPLACEMENT ET PREPARATION
- INSTALLATION
- PRÉPARATION DES PANNEAUX DÉCORATIFS
- ÉTAPES FINALES
- SERVICE
- SAFETY PRECAUTIONS - BEFORE YOU BEGIN
- MODEL NUMBERS
- RATING LABEL
- REGULATORY / CODE REQUIREMENTS
- PRODUCT WARNINGS / SAFETY
- LOCATION AND PREPARATION
- INSTALLATION
- OVERLAY PANEL
- FINAL STEPS
- SERVICE
AN INCORRECTLY CONNECTED GROUND WIRE MAY
GENERATE THE RISK OF ELECTROCUTION. IF IN DOUBT AS TO
THE CORRECT GROUNDING OF THE APPLIANCE, CALL IN A
QUALIFIED ELECTRICIAN OR THE TECHNICAL ASSISTANCE
SERVICE. DO NOT CHANGE THE PLUG ATTACHED TO THE
APPLIANCE.
THE PLUG AT THE END OF THE POWER CORD AND THE
CORRESPONDING OUTLET MUST BE OF THE SAME TYPE AND
MUST CONFORM TO LOCAL REGULATIONS GOVERNING
ELECTRICAL APPLIANCES. NEVER REMOVE THE PLUG BY
PULLING ON THE CORD.
CONDENSATION PROTECTION CONDENSATION PROTECTION
The steam guard protects the countertop from steam and
condensation when the door of the dishwasher is opened
at the end of the washing cycle.
Adhesive and screws are provided, to be used according
to installation requirements. See "INSTALLATION KIT
SUPPLIED WITH DISHWASHER" on page6.
Mount the steam guard as follows:
MOUNTING THE STEAM GUARD WITH SCREWSMOUNTING THE STEAM GUARD WITH SCREWS
If the countertop can be drilled for screws, use screws to mount the steam guard.
1. Mark and drill pilot holes if needed.
2. Position the guard and install mounting screws.
MOUNTING THE STEAM GUARDMOUNTING THE STEAM GUARD WITH ADHESIVE WITH ADHESIVE
If the countertop can't be drilled for mounting screws, use
adhesive to mount the steam guard.
1. Clean the front 6” of the underside of the countertop
directly above the door.
2. Peel the protective layer from the adhesive surface.
3. Apply the steam guard, pressing the guard firmly in place
to get full contact of the adhesive onto the mounting
surface.
NEXT STEPSNEXT STEPS
If your dishwasher is an overlay model, continue with the
instructions in the OVERLAY PANEL section.
If you have a model with stainless-steel or colored door,
proceed to "FINAL STEPS" on page16.
INSTALLATION
(CONT.)
2021 Hestan Commercial Corporation
13
EN