Installation Manual

INSTALLATION

(CONT.)

CONNECTING TO A WATER VALVE CONNECTING TO A WATER VALVE

Connect the inlet hose to a threaded 3/4” water valve using

the supplied filter. Firmly secure the hose by tightening its

ring nut with your hands; finish by tightening another 1/4

turn using a pair of plumbing pliers.

Note: A 3/8" x 3/4" brass adapter is also supplied to connect

to a 3/8" water line if needed.

The dishwasher can be filled with water at a temperature

of less than 140°F [60°C]. If the appliance is filled with hot

water, washing times will be reduced by about 20 minutes,

but efficiency will be slightly impaired.

• Recommended temperature: 120°F [49°C], max 140°F

[60°C].

• Recommended water pressure: 7-130 PSI [0.5 - 9 bar]. If

the pressure is too high, use a pressure reducer.

A rubber hose connected to a sink spray may burst if installed on the same pipes feeding the

dishwasher. If your sink is fitted with this accessory, remove the hose and plug the hole.

DO NOT CUT THE INLET HOSE

If the hose is cut, the dishwasher will not work, water will

leak and you may be injured. If the hose is too long, wind it

up neatly and place it behind the appliance. The cable

harness and electrical components must not come into

contact with the hydraulic system and the water inlet and

drain hoses.

When connecting the dishwasher drain hose to the sink make sure that the hose is not bent in

order to prevent cracks or breakages that could damage it.