Outdoor Ice Machine Installation and Instruction Manual GIMR15 GIML15 15” OUTDOOR ICE MACHINE RIGHT HINGE 15” OUTDOOR ICE MACHINE LEFT HINGE P/N 011026 rev B
WARNING Only qualified service technicians should install and service the ice machine. To obtain the name and phone number of your local Hestan Certified Service Representative, visit www.hestanoutdoor.com. No installation or service should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/manager should not proceed to operate the ice machine until the installer has instructed them on its proper operation.
IMPORTANT This manual should be read carefully before the ice machine is installed and operated. Read the warnings and guidelines contained in this booklet carefully as they provide essential information for the continued safe use and maintenance of the ice machine. Retain this booklet for any further reference that may be necessary. CONTENTS Important Safety Information.................................................................................................. 4 I. Specifications....................
Important Safety Information Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, damage to the appliance, or damage to property. WARNING Indicates a hazardous situation which could result in death or serious injury. NOTICE Indicates a situation which could result in damage to the appliance or property. IMPORTANT Indicates important information about the installation, use, and care of the appliance.
WARNING, continued • This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Children should be properly supervised around this appliance. • Do not climb, stand, or hang on the ice machine door or allow children or animals to do so.
I. Specifications A.
B. Electrical Data HESTAN ICE MACHINE MODEL NUMBER SERIAL NUMBER AC SUPPLY VOLTAGE AMPERES DESIGN PRESSURE REFRIGERANT GIM_15 115-120/60/1 3.8 AMPS HI-240PSI LO-120PSI 134a 4.2 OZ. Note: In the "MODEL NUMBER" the _ references either a (L) Left or (R) Right hinge model See the nameplate for electrical and refrigeration specifications. The nameplate is located inside the storage bin. We reserve the right to make changes in specifications and design without prior notice.
C. Dimensions/Connections Units: mm [in.
II. Installation Instructions WARNING • This ice machine must be installed in accordance with applicable national, state, and local codes and regulations. • CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that none have fallen into the storage bin. A. Checks Before Installation • Visually inspect the exterior of the shipping container and immediately report any damage to the carrier.
2. Built-In Installation Site NOTICE • Do not let the weight of the counter rest on the ice machine. • Do not install the ice machine in a corner where the door will interfere with other equipment or where the ice machine cannot be pulled out for service. Installation Space Model GIM_15 Height Width Depth 34" (864 mm) minimum 15" (381 mm) minimum 24" (610 mm) minimum Between Two Cabinets Min. 34" (864 mm) Between a Cabinet and the End of a Counter Min. 34" (864 mm) Min. 15" (381 mm) Min.
C. Setup 1) Position the ice machine in the selected permanent location. 2) Level the ice machine from side-to-side and front-to-rear by adjusting the feet. D. Electrical Connection WARNING • Electrical connection must meet national, state, and local electrical code requirements. Failure to meet these code requirements could result in death, electric shock, serious injury, fire, or severe damage to equipment. • This ice machine requires an independent power supply of proper capacity.
E. Water Supply and Drain Connections WARNING Water supply and drain connections must be installed in accordance with applicable national, state, and local regulations. NOTICE • Normal operating water temperature must be within 45°F to 95°F (7°C to 35°C). Operation of the ice machine, for extended periods, outside of this normal temperature range may affect ice machine performance.
• A water supply line shut-off valve and drain valve must be installed. A minimum of 1/4" nominal ID copper water tubing or equivalent is required for the water supply line. Be sure there is sufficient extra water supply line for the unit to be pulled out for service. • Water supply pressure must be a minimum of 10 PSIG and a maximum of 113 PSIG. If the pressure exceeds 113 PSIG, the use of a pressure reducing valve is required. • Drain outlet is 1/2" FPT.
III. Operating Instructions A. Important Notes About Usage WARNING • Only qualified service technicians should install and service the ice machine. • Failure to install, operate, and maintain the ice machine in accordance with this manual will adversely affect safety, performance, component life, and warranty coverage. • To reduce the risk of electric shock, make sure the control switch is in the "OFF" position before plugging in or unplugging the ice machine.
NOTICE • Protect the floor when moving the ice machine to prevent damage to the floor. • If using the optional drain pump (AGDP), test its operation every time the ice machine is cleaned and sanitized. See "IV.E. Optional Drain Pump AGDP" for details. If the optional drain pump is not operating properly, water could back up and overflow, leading to costly water damage. • To help ensure that the storage bin drain remains clear, follow the instructions in "IV.C.
4) Move the control switch to the "ICE" position and allow the ice machine to operate for 2 minutes. This allows the water tank to fill. 5) Move the control switch to the "OFF" position. 6) Inside the storage bin, disconnect the suction tube by squeezing the tabs and pulling the tube clear. See Fig. 31. Allow the water tank to drain. 7) Reconnect the suction tube as illustrated. See Fig. 32. Make sure the tabs lock into place; a loose fitting may cause a water leak.
IV. Maintenance This ice machine must be maintained in accordance with the instruction manual and labels provided with the ice machine. Consult with your local Hestan Certified Service Representative about maintenance service. WARNING • Only qualified service technicians should service this ice machine. • Failure to install, operate, and maintain the ice machine in accordance with this manual will adversely affect safety, performance, component life, and warranty coverage.
B. Cleaning and Sanitizing Instructions This ice machine must be cleaned and sanitized at least once a year. More frequent cleaning and sanitizing may be required in some water conditions. WARNING • To prevent injury to individuals and damage to the ice machine, do not use ammonia type cleaners. • Carefully follow any instructions provided with the bottles of cleaning and sanitizing solution.
6) Move the control switch to the "WASH" position. 7) Allow the cleaning solution to circulate for 30 minutes, then move the control switch to the "OFF" position. 8) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction tube. 9) Move the control switch to the "ICE" position and allow the ice machine to operate for 2 minutes. This allows the water tank to fill with water. 10) Move the control switch to the "WASH" position.
4) Disconnect the suction tube. Allow the water tank to drain. 5) Spread out the tabs to unlock the water tank, then slide it out. See Fig. 38. 6) Lift off the ice chute from the front frame pipe and then from the rear frame pipe. See Fig. 39. Rear Frame Pipe Tab Tab Ice Chute Front Frame Pipe Water Tank Fig. 38 Fig. 39 7) Disconnect the discharge tube from the spray assembly, then slide out the spray assembly. See Fig. 40. 8) Remove the two caps. See Fig. 41.
13) Position and lock the ice chute onto the front and rear frame pipes by pushing the ice chute down until it clicks onto both frame pipes. See Fig. 44. 14) Slide in the water tank along the rails at the bottom of the left and right brackets until it Left Bracket Right Bracket locks into place. See Fig. 45. Rear Frame Pipe Front Frame Pipe Rail Rail Fig. 44 Ice Chute Water Tank Fig. 45 15) Reconnect the suction tube.
29) Clean the storage bin liner, door liner, and door gasket with a neutral cleaner. Rinse thoroughly after cleaning. 30) Move the control switch to the "ICE" position to start the automatic icemaking process. C. Storage Bin Drain In some conditions, slime may build up inside the storage bin drain and prevent water from draining properly. To prevent this buildup, perform the following procedure once every 3 months or as often as necessary for conditions.
D. Condenser Check the condenser once a year, and clean if required by following the steps below. More frequent cleaning may be required depending on location. WARNING • Move the control switch to the "OFF" position and unplug the ice machine from the electrical outlet before cleaning the condenser. • To reduce the risk of electric shock, do not touch the control switch or plug with damp hands. • Condenser fins are sharp. Use care when cleaning.
5) If water pumps out properly and the drain pump then de-energizes, proceed to step 6. If water does not pump out properly and/or the drain pump does not de-energize, the appliance must be serviced by a qualified service technician before proceeding. 6) Move the control switch to the "ICE" position. 7) Pour another 24 to 30 oz. (710 to 890 ml) of water into the ice machine's ice storage bin, then completely restrict the discharge hose while the drain pump is operating. See Fig. 49.
V. Preparing the Ice machine for Periods of Non-Use During extended periods of non-use, extended absences, or in sub-freezing temperatures, follow the instructions below. When the ice machine is not used for two or three days under normal conditions, it is sufficient to move the control switch to the "OFF" position. WARNING Only qualified service technicians should service this ice machine.
Hestan Commercial 3375 E.
