Installation Instructions

HESTAN RESIDENTIAL INSTALLATION MANUAL
4
hestanoutdoor.com
SAFETY
PLEASE READ all instructions completely before attempting
to install or operate the unit. Take particular note of the
DANGER , WARNING and CAUTION information in the
manual. The information is important for the safe and
DANGER
Indicates a hazard that WILL result in serious injury or
death if precautions are not followed.
Indicates a hazard MAY cause serious injury or death if
precautions are not followed.
WARNING
Indicates a hazard where minor injury or product
damage may occur if precautions are not followed.
CAUTION
PRIOR TO INSTALLATION
Carefully inspect cabinet for hidden damage. If damage is
company. Hestan is not responsible for damage in transit.
When moving the unit, be sure
appropriate material to avoid damage from moving
the unit.
Do not lift unit by drawer, shelving
or door handles, as damage to the
unit could occur if not moved as instructed.
To
prevent personal injury, a
minimum of two people are
required to lift the unit. Larger units may require
additional personnel.
Before moving the unit, secure the door shut with tape
to prevent door from swinging open while being moved.
Carefully move unit to installation site and place in front of
opening.
If unit has been laid on its back or
sides, place unit upright and allow
minimum of 24 hours before connecting power.
CAUTION
CAUTION
WARNING
CAUTION
PLUMBING
No plumbing connections are required. Condensate from
the cooling coil is automatically evaporated through a
condensate pan located in the condensing section of the
unit.
ELECTRICAL
A 115 volt, 60 Hz, 15 amp circuit breaker and electrical
supply are required. A separate circuit is required for each
Hestan unit installed.
Follow the National Electrical Code and any local codes or
ordinances when installing the
receptacle.
All Hestan units come equipped with a NEMA 5-15P 90° plug
with a 5’ cord extending beyond the rear of the cabinet.
the wall surface for all Hestan models.
CAUTION
Do not attempt to operate the
equipment on any other power
Plate attached to the unit.
efficient installation, operation and care of your unit.
The electrical outlet must be flush with, or recessed into,
discovered, file your claim immediately with the transport
to protect finished flooring with
source than that listed on the Electrical Specification