Installation Guide

INSTALLATION

(continued)

INSTALLING THE FRONT GRILLE COVERINSTALLING THE FRONT GRILLE COVER

Once the unit is secured in place, install the

louvered front grille cover. Secure the cover

by snapping the latch into the latch catch on

the unit (Figure 3).

The vent grille must be removed to service the

unit. The floor cannot interfere with removal,

and the louvered sections must not be covered

or obstructed. Obstructions could prevent

proper air circulation, which may damage the

unit.

NOTE: To achieve maximum performance,

interior louver openings and fan guard

openings should never be obstructed.

SHELVING / DRAWER ADJUSTMENTSSHELVING / DRAWER ADJUSTMENTS

Completely empty shelf or drawer before removing.

1. Pull the shelf/drawer out to its furthest position.

Locate the tabs in the middle of both extenders.

Lift one tab up while pushing the opposite tab

down, and pull shelf/drawer out (Figure 4).

2. Position each bracket separately. Grasp the middle

of the bracket, pull the front end up and out, then

forward to remove it.

3. Place bracket at desired location. Push the bracket

rear hook into the rear mounting slot, then set

front of the bracket in the front slot.

4. Repeat for other brackets.

5. Push extenders completely into brackets. Align the

shelf/drawer grooves with the extenders and slide

completely into the unit.

Latch

Catch

Latch

Figure 3. Front Grille Cover Installation

Lift one tab on slide UP while

pushing tab on opposite slide

DOWN, and pull out to remove.

To remove brackets,

remove shelf, lift front of

bracket to disengage the

front key slot, then pull

forward to disengage the

rear key slot.

Figure 4. Shelving/Drawer Adjustment