Installation and Instruction Manual

INSTALLATION INSTRUCTIONS

(continued)

1. Make sure the space opening is correctly sized for the unit. See typical appliance dimensions on

page 7 and the chart below for finished rough opening requirements:

HEIGHT WIDTH DEPTH

34” [86.4 cm] min.

34-1/2” [87.6 cm] max.

15” [38.1 cm] 24” [61 cm]

2. Check that the following are level and square:

• Front and interior opening

• Installation opening and floor surface

• Countertop bottom front edge

NOTE: The floor under the unit must be at the same level as surrounding finished floor.

• To prevent possible damage to the countertop, do not place heavy objects on countertop directly

over unit.

• Do not let the weight of the countertop rest on the ice machine.

• Do not install the ice machine in a corner where the door will interfere with other equipment or

where the ice machine cannot be pulled out for service.

• The louvered sections at the front and rear of the unit must not be covered or obstructed.

Obstructions could prevent proper air circulation, which may damage the unit.

Min. 34"

(864 mm)

Min. 15"

(381 mm)

Between Two Cabinets Between a Cabinet and

the End of a Counter

Support: Do not

let the weight

of the counter

rest on the ice

machine

Min. 23"

(584 mm)

Oven

Ice machine

Between a Cabinet and

a Wall or Tall Cabinet

In a Corner

Secure: Do not