Installation and Instruction Manual

MAINTENANCE

(continued)

9. Soak all of the removed parts and the scoop in the sanitizing solution for 10 minutes. If the spray

assembly nozzles are clogged, clean them with a wire or a suitable brush.

10. Rinse the parts thoroughly with clean water.

11. Refit the 2 caps in their correct positions. Make sure the reducing pipe is in place in the center.

See Fig. 42.

12. Slide in the spray assembly along the rails on the left and right brackets. See Fig. 43. Connect the

discharge tube securely to the spray assembly; a loose fitting may cause a water leak.

Reducing Pipe

Rail

Fig. 42 Fig. 43

Right BracketLeft Bracket

Caps

Discharge Tube

13. Position and lock the ice chute onto the front and rear frame pipes by pushing the ice chute

down until it clicks onto both frame pipes. See Fig. 44.

14. Slide in the water tank along the rails at the bottom of the left and right brackets until it locks

into place. See Fig. 45.

15. Reconnect the suction tube.

16. Hook each separator onto the rail, then pull it hard towards you until it locks into place. See Fig.

46.

17. Replace the slope in its correct position. See Fig. 47.

Right Bracket

Rail

Fig. 44

Fig. 45

Left Bracket

Ice Chute

Front Frame

Pipe

Rear Frame

Pipe

Water Tank

Fig. 46

Fig. 47

Separator

Rail

Slope