Installation and Instruction Manual

MAINTENANCE

(continued)

SANITIZING PROCEDURESANITIZING PROCEDURE

1. Make sure the control switch is in the “OFF” position and the storage bin is empty.

2. Remove the slope from the storage bin by carefully bending it in the center and releasing it from

the 2 slope shafts. See Fig. 36.

3. Remove each separator by lifting it to the horizontal position and pushing it hard inward. See

Fig. 37.

Separator

Slope

Fig. 36

Fig. 37

Slope Shafts

4. Disconnect the suction tube. Allow the water tank to drain.

5. Spread out the tabs to unlock the water tank, then slide it out. See Fig. 38.

6. Lift off the ice chute from the front frame pipe and then from the rear frame pipe. See Fig. 39.

7. Disconnect the discharge tube from the spray assembly, then slide out the spray assembly. See

Fig. 40.

8. Remove the two caps. See Fig. 41.

Ice Chute

Front Frame Pipe

Tab Tab

Fig. 38 Fig. 39

Rear Frame Pipe

Water Tank

Discharge Tube

Spray Assembly

Fig. 40 Fig. 41

Caps