Installation and Instruction Manual

OPERATING INSTRUCTIONS

(continued)

STARTUPSTARTUP

All parts are factory-adjusted. Improper adjustments may adversely affect safety, performance,

component life, and warranty coverage.

• If the ice machine is turned off, wait for at least 3 minutes before restarting the ice machine to

prevent damage to the compressor.

• At startup, confirm that all internal and external connections are free of leaks.

1. Open the water supply shut-off valve.

2. Make sure the control switch is in the “OFF” position. Plug the unit into the electrical outlet.

WARNING! To reduce the risk of electric shock, do not touch the control switch or plug with

damp hands. If you have to slide the unit back for a built-in installation, make sure you do not

damage or pinch the water supply line, drain line, or power cord.

3. If required by sanitation code in your area, seal the perimeter where the machine touches the

floor with approved caulk compound in a smooth and easily cleanable manner.

4. Move the control switch to the “ICE” position and allow the ice machine to operate for

2 minutes. This allows the water tank to fill.

5. Move the control switch to the “OFF” position.

6. Inside the storage bin, disconnect the suction tube by squeezing the tabs and pulling the tube

clear. See Fig. 31. Allow the water tank to drain.

7. Reconnect the suction tube as illustrated. See Fig. 32. Make sure the tabs lock into place; a loose

fitting may cause a water leak.

Water Tank

Drain

Suction Tube

Tabs

Fig. 31 Fig. 32

Suction Tube

Tabs

8. Clean the storage bin liner, door liner, and door

gasket using a neutral cleaner. Rinse thoroughly after

cleaning.

9. Move the control switch to the “ICE” position to

start the automatic icemaking process.

10. To confirm bin control operation, hold ice in contact

with the bin control thermostat bulb. NOTICE! If the

ice machine does not stop within 10 seconds, the bin

control thermostat must be adjusted. Installation at

higher altitude locations are more likely to require

adjustment. See Fig. 33.

Fig. 33

Bin Control

Thermostat