Tubular Burner Conversion Kit

BURNER INSTALLATION

1. Hestan Grills feature Trellis Burners (shown below), while Aspire Grills feature U-Burners. Both

burners install the same way by inserting the end of the burner air-shutter onto the valve / orifice,

while carefully twisting the burner to clear the igniter shroud. The burner should fully seat with the

orifice protruding into the air shutter as far as possible (see image on pg. 4), while the rear “hook”

rests flat on the burner hanger at the back of the firebox.

2. Adjust the shroud down onto the burner so it hugs the cross tube / channel as close as possible, but

not so far that the burner will not lay flat on the burner hanger at the back of the firebox. Tighten

the screws on either side of the shroud.

IGNITER SHROUD