Installation Instructions

ManualsBrandsHestan ManualsBeverage Centers24 Inch Drop-In Cooler with R-Tech Insulated Walls, 5 Condiment Trays and Lid Props

DROP-IN COOLER

EDC24

CUTOUT DIMENSIONS AND INSTALLATION

IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN

INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER

1. Your new Aspire Drop-in Cooler is completely pre-assembled. The cutout dimensions in your island are

shown below. Some provision must be made in the island for drainage. The bottom of the unit has a 1/2”

NPS threaded connection.

Some parts have sharp edges. Care must be taken when handling the various components to avoid personal

injury. Wear gloves when handling.

Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper and

initiate a damage claim. Hestan Commercial Corp. is not responsible for shipping damage. DO NOT discard

any packing material (box, pallet, straps) until the unit has been inspected.

Remove all exterior packaging materials, banding, tape, etc. Remove all protective film from the inside of your

cabinets. You may leave any exterior protective film on until after installation is complete.

Summary of content (5 pages)

PAGE 1
DROP-IN COOLER Installation Instructions EDC24 IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER Some parts have sharp edges. Care must be taken when handling the various components to avoid personal injury. Wear gloves when handling. Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper and initiate a damage claim. Hestan Commercial Corp. is not responsible for shipping damage.
PAGE 2
INSTALLATION (continued) 2. As seen in this installation, an Aspire Access Door is mounted underneath the Drop-In Cooler to allow access to the drain connection. This is not a requirement and your professional outdoor equipment installer may find another way to drain the unit elsewhere. The weight of the Drop-In Cooler will hold the unit it in place. However, you may want to apply a bead of clear silicone sealant around the perimeter of the outer frame to your countertop.
PAGE 3
PARTS LIST Please visit the Hestan website to access the parts list for your Hestan Outdoor product: www.hestanaspire.com. SERVICE All warranty and non-warranty repairs should be performed by qualified service personnel. To locate an authorized service agent in your area, contact your Hestan dealer, local representative, or the manufacturer. Before you call, please have the model number information ready. This information is shown on a sticker affixed to one of the inside vertical surfaces of your product.
PAGE 4
LIMITED WARRANTY (continued) 4. All other grill components are warranted to be free from defects in material and workmanship, under normal non-commercial use and service, for a period of two (2) years from the original date of purchase. This is limited to replacement of the defective parts, with the Purchaser paying all other costs, including labor, shipping, and handling, as applicable.
PAGE 5
RETAIN THIS MANUAL FOR FUTURE REFERENCE Hestan Commercial Corporation 3375 E.