Installation Sheet

IGNITERS

The spark igniter on the center burner is partially exposed and can be contaminated in the event you

have a boil-over when using the Power Burner. You can gently clean it with a soapy water solution

and a toothbrush. Wipe down with a clean cloth. The spark igniter for the octagonal burner is also

similarly exposed and subject to contamination. Exercise more caution when attempting to clean

this igniter as its position relative to the burner is critical for proper ignition and to reduce the

chance of nuisance sparking during operation.

NOTE: Rough handling of the igniter can crack the ceramic body, causing it to fail. Handle with care.

ADDITIONAL CONSIDERATIONS

Always keep the area around the Power Burner free of obstructions and debris. Maintain at least 9”

[23 cm] of space around the Power Burner to ensure proper airflow, and keep all ventilation openings

clear and free of debris. Clean the appliance after each use, and check for blockages, especially at

the burner orifices, after periods of prolonged non-use. To maintain the appearance of your Hestan

Power Burner for many years, keep it covered when not in use. Backyard environments are harsh on

your appliance’s finish. Long exposure to sun, water, yard chemicals and the elements could diminish

the appearance of the stainless steel. This is very evident in ocean-front locations.

Our appliance materials have been tested in saline solutions with higher salinity than seawater.

They have also been tested by exposure to highly acidic foods. During and after these tests, we

found these materials were able to withstand exposure over prolonged periods of time. However,

the above-mentioned corrosive substances, along with neglect, can lead to a situation whereby

conditions might combine to cause some damage to occur. Therefore, we suggest that you always

keep your Power Burner clean, dry and covered when not in use. This is even more important when

long term storage is required. Always store the Power Burner clean, dry and covered with your

Hestan Power Burner cover. A dirty Power Burner will attract insects and rodents which is highly

unsanitary. In addition, rodents are known to chew on the insulation of wiring which will cause

permanent damage to the wiring and possibly electrical components.

For those in desert communities, wind-driven sand is highly abrasive and constant exposure will

eventually pit and scratch the surface. Another reason to keep your Power Burner covered when not

in use.

CLEANING AND MAINTENANCE

(continued)