Quick Start Guide

CHANGING ORIFICES

(continued)

3. Use a nut driver or deep socket wrench (9/32” or 7 mm) to remove the two orifices from the orifice

holder. Install the new orifices and remount the burner base in the same manner it was removed.

Repeat this process for the secondary burner if applicable.

GAS SUPPLY

The local gas authority or supplier should be consulted at the installation planning stage in order to

establish the availability of an adequate supply of gas (NG or LP). If it is a new installation, have the

gas authorities or supplier check the meter size and piping to assure that the unit is supplied with the

necessary amount of gas supply and pressure to operate the unit(s).

Gas connections should be made by a qualified plumber, or your professional outdoor appliance service

technician.

All fixed (non-mobile) appliances must be fitted with an accessible upstream gas shutoff valve as a means

of isolating the appliance for emergency shut off and for servicing.

Make certain new piping and connections have been made in a clean manner and have been purged so

that piping compound, chips, etc. will not clog regulators, valves, orifices, or burners. Use pipe joint

compound / thread sealant approved for natural and LP gases.

CHANGING REGULATORS