Product Manual

Operating Instructions & Parts Manual
R
General Safety Information
Read all instructions before
operating, installing or xing the
evaporative air cooler.
This product operates at 110-120V
AC, 60 Hz only
Do not use with a damaged cord or
plug, and keep the cord away from
heated surfaces.
1.
2.
3.
Do not insert any foreign objects
into the air inlet or outlet, body
injury or property damage may
occur.
Do not operate this product near an
open re, it may ignite and cause
re, resulting in body injury or
property damage.
Do not operate in areas where
gasoline, paint or other ammable
liquids are used or stored.
4.
5.
6.
If the power
supply cord is
damaged, it must be replaced by
a qualied person in order to
avoid a hazard.
maintenance, the air cooler must
be unplugged.
Prior to cleaning
or other
Always unplug the power cord
from receptacle when the air
cooler is not in use, before
cleaning, replacing parts, or
before moving to another
location.
7.
Do not plug the cord into
electric outlet with wet hands,
an electric shock may result.
Never attempt to disassemble
or alter the product in any way
not instructed by this manual.
Shock, re, or body injury may
occur.
8.
9.
10.
11.
Use only on GFCI protected
receptacle.
Do not use this appliance in the
inmediate surrounds of a bath, a
shower or a swimming pool or
other liquids.
To reduce the risk
of re or electric
schock, do not use this fan with any
solid-state speed control device.
Installation
Window Models: W48, W38 and W28
NOTE: To be installed by a licensed
professional technician.
Take the measurments of the neck
and open the wall or window
accordingly.
Remove the front grill from the unit
by unscrewing the bolts.
1.
2.
NOTE: Be careful not to unplug the
front switches.
Install the unit through the wall or
window opening.
Secure the unit to the wall or
window and support the weight of
the unit if above the ground.
4.
3.
NOTE: The weight of the unit is
increased when water is added.
Level unit horizontally.
Install oat and drain valve (see
pages 4 & 5).
Check all water connections.
Connect unit to 110-120V GFCI
receptacle.
5.
6.
7.
8.
Installation
Portable models M28, M38
Set your equipment in a well
ventilated area
Adjust the breaks of the wheels to
avoid movement of your equio-
ment
Install the oat valve and overow
tube (see pages 4 & 5)
Plug the water hose with the oat
valve, or add water inside the unit
removing one of the walls (lters,
taking care of not wet the motor),
and set it back.
Connect the equipment (plug) to a
GFCI receptacle of 110-120V
1.
2.
3.
4.
5.
2