Use and Care Manual

Cooler Maintenance
Cleaning Filters and Rigid Media Pads
Pull out the filter from
the top
The removable filters can be washed and media
pads can be sprayed out on the ground to clean.
Use light pressure when spraying pads. You can
use a soft bristle brush to gently wipe away
deposits. NEVER spray pads with water while
cooler is operating, and fan is running. This can
cause damage to motor and will void the
warranty.
Removal of the Back Panel (Disconnect power
supply before this procedure.)
Unscrew the screws
in the back panel
first, then pull the
back panel up.
Pull out the bottom of
the back panel then
take it down.
Removal and Replacement of Cooling Media
1. If your cooler includes media pins,
remove by unscrewing/pulling out the
disc.
2. Remove media pad. Replace with new
pad.
3. Reinstall the back panel and you are
ready to use the cooler again.
Go to www.hessaire.com for instructional videos
and tips for eliminating any odors.
Draining the Cooler Tank
1. Pull or unscrew drain plug/cap from drain
assembly.
2. Tip unit to ensure all water exits the unit.
3. Replace drain plug.
Hose Adapter
Our convenient hose adapter allows you to have
continuous water fill. Never leave your cooler
unattended.
Be sure your float valve is adjusted at a forty-
five-degree angle never straight downward
insuring it does not hit media panel. This will
assure no overflow
Use all precautions and
disconnect from power source
b
efore performing any
m
aintenance.