User's Manual
Table Of Contents
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Phoenix Contact
- Appendix V Nonlinear Reflectivity Mapping
- Appendix VI Certification Info
- Appendix VII Support and Contact
34
5.2 Use
Set the PC’s IP address according to Section 2.4 Use.
◼ Check Live Data
◼ Open a PCAP File
Click on and select your LiDAR model to begin receiving data over
Ethernet.
Click on to pop up the “Choose Open File” window. Select a PCAP
file to open.
◼ Record a PCAP File
◼ Import a Correction File
Click on to pop up the “Choose Output File” window.
Click on “Save” to begin recording a PCAP file.
Click on again to stop recording.
Figure 5.2 Choose Output File
Each LiDAR comes with a correction file (.CSV) in the provided USB disk.
When a PCAP file is open, click on “File” in the menu bar and “Import
Correction File”.
Figure 5.3 File Menu