User's Manual
Table Of Contents
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Phoenix Contact
- Appendix V Nonlinear Reflectivity Mapping
- Appendix VI Certification Info
- Appendix VII Support and Contact
30
4.3.3 Multi-section FOV
Users can configure up to ten continuous angle ranges (i.e. sections) for each channel.
By default, the status button for each channel is green, indicating that multi-section configuration is active.
To deactivate the multi-section configuration for one channel, click the corresponding button to make it gray. Thus the angle range for this channel
becomes [0°，360°].
Click the “Enable/Disable All” button to activate/deactivate the angle range configuration for all channels.
· · ·
· ·
· ·
· ·
Figure 4.7 Multi-Section Azimuth FOV