User's Manual
Table Of Contents
- Contents
- Safety Notice
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Certification Info
- Appendix V Support and Contact
49
(Continued)
3) Spray the enclosure with warm, neutral solvent using a spray bottle
Solvent type
99% isopropyl alcohol (IPA)
or 99% ethanol (absolute alcohol)
or distilled water
Solvent temperature
40 to 60 ℃
4) When the stains have loosened, dip a piece of lint-free wipe into the solvent made in Step 3, and gently wipe the enclosure back and forth
along its curved surface
5) Should another cleaning agent be applied to remove certain stains, repeat Steps 3 and 4
6) Spray the enclosure with clean water, and gently wipe off the remaining liquid with another piece of lint-free wipe