User's Manual
Table Of Contents
- Contents
- Safety Notice
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Certification Info
- Appendix V Support and Contact
41
5.2 Use
Set the PC's IP address according to Section 2.4 (Get Ready to Use)
■ Check Live Data
■ Open a PCAP File
Click on and select your LiDAR model to begin receiving data
over Ethernet.
Click on to pop up the "Choose Open File" window. Select a
PCAP file to open.
■ Record a PCAP File
■ Import a Correction File
Click on to pop up the "Choose Output File" window.
Click on "Save" to begin recording a PCAP file.
Click on again to stop recording.
Each LiDAR contains a correction file in .CSV format. When opening
a PCAP file in PandarView, the correction file is automatically
uploaded.
In case the correction file is lost, click on "File" in the menu bar and
"Import Correction File".