User's Manual
Table Of Contents
- Contents
- Safety Notice
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Certification Info
- Appendix V Support and Contact
32
4.2 Settings
(Continued on the next page)
1. Control IP
VLAN Tagging can be used when the receiving host also
supports VLAN function.
· Check the VLAN checkbox and input a VLAN ID (1~4094)
· Set the VLAN ID of the receiving host to be the same
2. Destination IP
Mode
Destination IP
Broadcast (default)
255.255.255.255
Multicast
239.0.0.0~239.255.255.255
Unicast
Same as the PC's IP address
3. LiDAR Functions
Spin Rate
600 rpm / 1200 rpm
Return Mode
Last / Strongest / Dual Return
UDP Sequence
OFF / ON #1 / ON #2
Point Cloud UDP packets can be labeled
with a sequence number, see Section 3.1.
ON #1: UDP sequence increments only
when UDP packets are generated.
ON #2: UDP sequence increments even
though no UDP packet is generated
outside the user-specified azimuth FOV.
(continued on the next page)