User's Manual
Table Of Contents
- Contents
- Safety Notice
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Certification Info
- Appendix V Support and Contact
14
2.3.1 Connection Box Interfaces
Figure 2.7 Connection Box (Front)
Figure 2.8 Connection Box (Back)
Port #
Port Name
Description
a
Standard Ethernet Port
RJ45, 100 Mbps Ethernet
b
Power Port
Connects to a DC power adapter
External power supply: 9 V to 36 V, at least 30 W
Port size: Φ6.3 mm (external), Φ2 mm (internal)
c
GPS Port
Connector type: JST SM06B-SRSS-TB
Recommended connector for the external GPS module: JST SHR-06V-S-B
Voltage standard: RS232 Baud rate: 9600 bps
The GPS port pin numbers are 1 to 6 from left to right, defined as follows:
Pin #
Direction
Pin Description
Requirements
1
Input
PPS (pulse-per-second) signal for synchronization
TTL level 3.3 V/5 V
Recommended pulse width: ≥1 ms
Cycle: 1 s (from rising edge to rising edge)
2
Output
Power for the external GPS module
5 V
3
Output
Ground for the external GPS module
-
4
Input
Receiving serial data from the external GPS module
RS232 level
5
Output
Ground for the external GPS module
-
6
Output
Transmitting serial data to the external GPS module
RS232 level