User's Manual
Table Of Contents
- Contents
- Safety Notice
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Phoenix Contact
- Appendix V Nonlinear Reflectivity Mapping
- Appendix VI Certification Info
- Appendix VII Support and Contact
17
3 Data Structure
100 Mbps Ethernet UDP/IP is used for data output. The output data includes Point Cloud Data Packets and GPS Data Packets.
Figure 3.1 Data Structure with UDP Sequence OFF
The UDP sequence feature is OFF by default. When UDP sequence is ON, the Additional Information in the UDP data changes from 22 bytes to 26 bytes.