Installation Guide

Install the wall channel. Secure the wall channel using ST3.5x35 screws in the holes from the

previous steps.

Install the wall bracket. The wall bracket consists of two pas; now, remove the inner pa,

which is the bracket base, as shown in the pictures. The bracket base may tend to slide down on

the single mounting screw. So, once you have determined the appropriate height (ensuring that

there is a large enough gap at the bottom of the door for it to slide easily through the bottom

guide), disassemble it, mix up the epoxy putty, and apply some to the slotted hole above the

screw head on both bracket bases.

Install the wall plugs.

STEP 5

STEP 6

The bracket base

mounting hole might slip,

so you may need to use

epoxy or shims.