User Manual

5
Additional stereo inputs and outputs should be wired to the additional
inputs/outputs.
LFE MODE CONFIGURATION
The RAM System 5000 allows your 5.1 LFE speaker to act as the subwoofer in
the additional stereo pair of speakers, a feature missing in most competing
products.
In case the same LFE speaker in your 5.1 system is to be used with your
additional stereo pairs of monitors, the unit can be configured so a mono
signal following the stereo inputs is always present at OUTPUT 2R (LFE).
In order to do so, please press SHIFT + INPUT 2 and confirm. Pressing again
and confirming reverts the configuration. Again, save the status so your
configuration is stored.
In case Stereo mode is selected (no 5.1) a discrete Sub channel is configured,
and OUT 2 is disabled (as it is dedicated for sub purposes!!).
INPUT FEATURES
The RAM System 5000 has the following stereo inputs:
• INPUT 1 to 4: Balanced, accessible on a DSUB 25 connector which
follows the Tascam protocol. Input 1 is also duplicated on a pair of
XLR connectors for ease of use. Nominal level is +4 dBu. Depending
on 5.1/ST and LFE mode configurations, Inputs 1 to 3 represent the
5.1 system or are individual stereo inputs.
• UNBALANCED INPUT: Accessible on a pair of RCA connectors, its
nominal level is -10dBV.
• DIGITAL INPUT: Based on the Wolfson WM8741 DAC (still the best to
our ears!!), it features AES/EBU, TOS Link and Spdif connectors.
Inputs are transformer isolated and read the word clock from the
digital incoming signal. A maximum of 24 bit/192 Khz is allowed and