User Manual

3
Plugging the unit will display a welcome message and firmware unit´s
version. Please note that after turning on the unit, MUTE will always be
engaged regardless of the level shown on the red knob. This is to prevent
damage of your speakers due to excessive level on startup.
Any connection problems, the remote will show the message “NO CONSOLE”
and will try to reconnect again. It is normal to have this message for a few
seconds when turning on, no worries.
Any time you plug the unit on, the status of the RAM System will be that of
the last time it was stored, so there is no need to reset preset levels or
talkback gain. Last input and output chosen is also stored.
In order to save your preferred status, press SHIFT + OUT4 (SAVE STATUS)
GENERAL DESCRIPTION
The Heritage Audio RAM SYSTEM 5000 is a professional 5.1 ready monitor
controller in a convenient split format. With its matrix of inputs and outputs,
covering balanced and unbalanced analog, all common digital formats on a
state of the art Wolfson DAC, and the innovative professional quality HA
Bluetooth technology, the System 5000 will cover all the monitoring needs of
the most demanding professional facilities at a price never heard before.
The level control is taken care of by means of microprocessor controlled gold
plated relays, giving an exceptional resolution of 64dB of attenuation in 1dB
steps. Keeping active electronics to a minimum, the attenuator is buffered
using premium Burr Brown circuitry for negligible coloration and no noise.
Headphone monitoring is as critical as main speaker is. Usually a weak part
even in the most expensive units, the RAM System 5000 employs very high
current drivers in a diamond buffer configuration which are able to drive any
headphones to very high levels without coloration or noise. It has 2 amplifiers