User Manual

14
CALLIBRATION OF THE RAM SYSTEM 5000
The Heritage Audio RAM SYSTEM 5000 is calibrated to be unity gain from
input to output straight from the factory and therefore it does not require
further calibration. However, some 5.1 installers may suggest you to trim
some outputs (specially LFE) from the monitor controller. We strongly
suggest doing so on the power amps, but individual output trimmers are
accessible at the front panel of the unit via a small flat screwdriver. WE
STRONGLY SUGGEST LEAVING THEM ALONE AND RECALIBRATION IS NOT
COVERED BY WARRANTY.
PAIRING OF THE MAIN AND REMOTE UNITS
Both the main and remote units are programmed with unique ID codes
straight from the factory, so the form a unique pair. No other remote units
will pair with your main unit (or vice versa).
In case you are getting pairing (connecting) issues, please RESET both units as
follows:
- Main Unit Reset: Turn power off on both remote and main units.
Please power the main unit again, keeping the red RESET button
pressed for at least 3 seconds. Power off and on again.
- Remote Reset: Turn power off and power on again while pressing
SHIFT + OUT3. Confirm that you would like to reset by pressing OUT 3
again when asked. Turn off and on.
This simple process should restore the communication between main and
remote unit.