User Manual

2
INSTALLING THE RAM SYSTEM 2000
Thanks for purchasing the RAM System 2000. Please make sure the following
items are in the box when you open it.
• This manual.
• RAM System 2000 main unit.
• Power Supply labelled HA-PSU03.
• Bluetooth antenna.
• IEC Cable.
Depending on your system requirements, you will need several TRS cables to
hook up your system. Please check your input sources and output
destinations and buy the correct cables.
Additionally, please insert the Bluetooth antenna in its threaded connector in
case it comes unplugged from the factory.
The power supply is of the auto switching type so it works worldwide without
adjusting anything. In case your country uses a different mains cable other
than the one provided in the box, just get the correct one and you are done.
Plugging the unit will display a welcome message and firmware unit´s
version. Please note that after turning on the unit, MUTE will always be
engaged regardless of the level shown on the red knob. This is to prevent
damage of your speakers due to excessive level on startup.
Any time you plug the unit on, the status of the RAM System will be that of
the last time it was turned off, so there is no need to reset preset levels or
talkback gain. Last input and output chosen is also stored.