Operation Manual

DJ Console 4-Mx controls
01. Play/Pause
02. Cue (Place cue points)
03. Stop (go back to cue point)
04. Jog wheel (browse, scratch and pitch bend)
05. Rewind/fast forward
06. Sync: synchronize the BPM with the other deck being controlled
07. Pitch Scale -/+: reduce/increase the pitch fader scale
08. Pitch fader: set the playback speed
09. Pitch Reset status: shows when the pitch is virtually at neutral
10. Pitch Bend -/+: temporarily change the playback speed
11. Microphone connector (1/4” jack / 6.35mm)
12. Microphone volume
13. Deck Switch: switch controls between A/C (left), B/D (right)
14. Microphone On/Off
15. Shift: switch functions 1 to 6 into functions 7 to 12
16. Buttons 1-6: assignable functions 1 to 6 and 7 to 12
17. Modulate: modulate last function loaded
18. Kill: mute a frequency band (treble/medium/bass)
19. Source: replace the playback of the track loaded
on the deck with the external source pass-
through (input 1-2 on left deck, input 3-4 on right
deck)
20. Gain knob: adjust the maximum level on the deck
21. Scratch: enable scratch mode on jog wheels
22. Main volume: set the volume on output 1-2
23. Browsing controls: controls browsing in the folder
and files browser
24. Load On deck: load selected track on the deck
25. Equalization knobs: set treble, medium and bass
levels on the deck
26. Cue Select: include this deck in the headphone
preview
27. Cue/Mix: choose what you hear on your
headphones, between Cue (preview the deck you
have selected with the Cue Select buttons) and
Mix (the music you play for the audience)
28. Headphone volume
29. Headphone connector (1/4” jack / 6.35mm)
30. Controlled deck viewer: shows which virtual deck
is being controlled on DJ Console 4-Mx
31. Cross fader: mix the music between the left
deck(s) (A and C) and the right deck(s) (B and D)
32. Volume fader: set the volume on the deck
Software takeover:
After switching decks, you must first take over the
software positions of the following controls
08. Pitch fader
20. Gain
25. Equalization knobs (treble/medium/bass)
32. Volume fader
Each gradual control must reach the same position on the
DJ Console 4-Mx hardware as the position shown in the software, before
you can control the setting in question.