Operation Manual

User Manual – 13/30
Please note that the Cue/Mix knob is a software function only (and not a hardware
function). This means that when you are using the VirtualDJ software, the knob functions as
described above; while if you are not using DJing software, this knob will have no function –
unless you map a “Cue to Mix” function onto it.
4.2. The back panel
ENGLISH
DJ Console 4-Mx has a USB connector on its back panel, allowing you to connect it to your
computer. As DJ Console 4-Mx is USB bus-powered, no external power source is required.
FRANÇAIS
ITALIANO DEUTSCH ESPAÑOL NEDERLANDS
RCA mono output
connectors 3-4
RCA mono output
connectors 1-2
1/4” (6.35mm) mono
output connectors 3-4
RCA mono input
connectors 3-4
RCA mono input
connectors 1-2
1/4” (6.35mm) mono
output connector 2
1/4” (6.35mm) mono
output connector 1
Ground Lift
switch
Phono ground
connector
USB connector
When connecting a microphone, the microphone can only be used on input channels 1-
2 (please see the front panel description, below). For more information on selecting input
levels for inputs 1-2 and 3-4, please refer to chapter 5.3.1. General control panel settings.
The Ground Lift switch, available on the 1/4” (6.35mm) mono output connectors 1 and
2, can be useful in the event that a ground loop is disturbing the connection between the
console and a power amplifier. In a room with a proper electrical setup, it is safer and better to
keep the Ground Lift switch Off (the default setting). The Ground Lift switch is not active on
RCA outputs 1-2.