User Guide

68
NVIDIA Corporation
C
HAPTER
6 TwinView Basics: Windows XP/2000/NT 4.0
8 You can use similar steps as described in this section to switch to TV as the
primary display (Figure 6.31).
Figure 6.31
TwinView Clone Mode (Display 1 = TV): Windows 2000
Change Resolution: Clone Mode (Virtual Desktop)
You can use the Change Resolution option to modify Resolution and Refresh
Frequency for the secondary display, which allows you to enable Virtual
Desktop, a useful feature for panels and monitors with limited resolution. This
feature lets you pan-and-scan the entire desktop area on the secondary display
when its resolution is set to less than the value set on the primary display.
Note: If the maximum resolution of the secondary display is less than the
current resolution of the primary display, once you enable Clone mode
from the TwinView panel, Virtual Desktop will already be enabled.
However, you still may want to adjust the resolutions of the primary and/
or secondary device by using the Device Configuration dialog box
(Figure 6.32) for the secondary display or the Windows Settings control
panel of your primary display.
Follow these steps to enable Virtual Desktop:
DetXP_Features.book Page 68 Thursday, October 11, 2001 3:53 PM