User Guide

NVIDIA Corporation
31
Detonator XP User’s Guide
Figure 5.15
TwinView Std. Mode (Display 1 = TV): Windows 98
6
To switch back to the CRT or DFP, you can follow the procedures in this
section, substituting either the Analog Monitor or the Digital Flat Panel
option on the Device Selection panel, as applicable.
Clone Mode
Note: This section does not apply if you have only one display device attached.
In Clone mode, two monitors display identical images, which is useful for
presentations. A presenter may use the smaller monitor on the podium, while a
projector monitor reflects the presentation to the audience.
Note: Under Clone mode, when you switch to full-screen Microsoft DOS
window or boot to a DOS prompt, the display is limited to the
primary display device.
The example in this section starts with the analog monitor (CRT) as the primary
display.
1
To access TwinView Clone mode, click the Clone mode option on the
TwinView control panel and click Apply.
Your DFP display becomes enabled and you can see your current screen
duplicated on the clone (DFP) display.
DetXP_Features.book Page 31 Thursday, October 11, 2001 3:53 PM