User Guide

96
NVIDIA Corporation
C
HAPTER
8 Video Mirror
The options on the Overlay Controls panel can be used on a single video image
or display when you are in TwinView Standard mode. However, the Video
Mirror Controls work only when you are in the following modes:
• Windows XP/2000 TwinView Clone or Windows XP DualView
Note: Video Mirror is not available under Windows NT 4.0.
• Windows 9x TwinView Clone or Extended Desktop (non-TwinView)
Overlay Controls
Note: Be sure to click Apply whenever you make any changes to the control
panels. If changes do not take effect (e.g., the controls have no effect on
the video) after you click Apply, close the video overlay and then re-open
it.
1 Open the DVD or video application that you want to view.
2
For Video Mirror functionality, set your TwinView panel to one of these
modes:
•
Windows XP/2000 Clone or Windows XP DualView
•
Windows 9x Clone or Extended Desktop
3 To access the Overlay Controls panel, click Properties > Settings tab >
Advanced button > GeForce2 MX tab > Additional Properties button >
Overlay Controls tab.
Figure 8.1 through Figure 8.4 shows the Overlay Controls panels using
examples for GeForce3 and GeForce2 MX GPUs.
Note: If you are using a GeForce2 MX GPU-based card and your TwinView
panel is set to Standard mode, the Video Mirror controls are enabled
as shown in Figure 8.2 but they will have no effect until you enable
TwinView Clone mode under Windows XP/2000 or either TwinView
Clone or Windows Extended mode under Windows 9x.
4 For description of the Overlay Settings, see “Overlay Settings” on page 97
below.
5 To use the Video Mirror controls, go directly to the next section “Video
Mirror Controls” on page 99.
DetXP_Features.book Page 96 Thursday, October 11, 2001 3:53 PM