Instructions / Assembly

24
Sharpening The Cutting Blade
1. start and stop your hedge trimmer
until the cutter blade and the guard are
slightly offset, as shown in Fig. 9. This
will allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from you
hedge trimmer.
3. clamp the blade assembly in a vise
and file the exposed cutting surface
of each blade tooth. Remove as little
material as possible. Be sure to retain
the original angle of each tooth when filing.
4. Remove the hedge trimmer from the vise; restart it and stop it to expose the
unsharpened edges of the blade teeth.
5. Remove the battery pack and repeat the sharpening procedure above.
NOTE: do not operate your hedge trimmer with dull or damaged cutting blades.
This may cause overload and will give unsatisfactory cutting results.
Lubricating the blade (fig. 10)
For best operation and longer blade life,
lubricate the hedge trimmer blade with
light weight machine oil before and after
each use.
1. Remove the battery pack from the
hedge trimmer.
2. Lay the hedge trimmer on a flat
9
10