TDS
Henry
®
812 RoofSaver™ Clear Sealer
Henry
®
Company, 999 N. Pacific Coast Highway, Ste. 800, El Segundo, CA 90245
Tel: 800-486-1278 Email: techservices@henry.com
www.henry.com
Revision Date: 5/8/2020
NOTE: DO NOT THIN. Not for use on completely flat roofs or where ponding water may be present. Not intended to repair leaks or
to waterproof. Do not apply if rain or temperatures below 50 °F (10 °C) are expected within 24 hours of application (low
temperatures and/or high humidity may require longer drying time). When in doubt, consult membrane manufacturer for membrane
warranty considerations before use. DO NOT ALLOW SEALER IN PAIL TO FREEZE. Do not heat container or store at
temperatures >120 °F (>49 °C). When transporting, make sure the pail is secured and the lid is tight to prevent spills.
Please consult Henry® Product Support for any specific questions regarding the application of this product.
Coverage Rates
Smooth Surfaces: Approximately 200 square feet per 1 gallon size container.
Rough Surfaces: Approximately 100 square feet per 1 gallon size container, depending on porosity and roughness of substrate.
Clean-Up
Before sealer dries, clean hands, tools, spillage, etc., with warm soapy water. If sealer has dried, clean hands with waterless hand
cleaner. Soften the dried film on tools with mineral spirits, then scrape clean. When using mineral spirits, exercise safe practices
concerning flammability and toxicity.
Packaging
1 gallon size container
Limited Product Warranty
We, the manufacturer, warrant only that this product is free of defects, since many factors which affect the results obtained from this
product - such as weather, workmanship, equipment utilized and prior condition of the substrate - are all beyond our control;
therefore, Henry Company cannot guarantee results of the application of the sealer including, but not limited to: appearance, water
tightness, and suitability of the substrate. The substrate to be coated must be structurally sound and have reasonable life
expectancy prior to being coated. We will replace at no charge any product proved to have a material defect within 5-years of
purchase, provided it has been applied in accordance with our written directions for uses we recommended as suitable for this
product. Proof of purchase must be provided. This warranty is void if the sealer is coated over, patched, painted, or covered in any
way with any product other than this sealer or approved products. DISCLAIMER OF WARRANTIES AND LIMITATION OF
LIABILITY: THIS LIMITED WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT
NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
MANUFACTURER SHALL HAVE NO LIABILITY OF ANY KIND BEYOND PRODUCT REPLACEMENT, INCLUDING FOR
CONSEQUENTIAL, EXEMPLARY OR INCIDENTAL DAMAGES RESULTING FROM ANY DEFECTS OR ANY DELAYS
CAUSED BY REPLACEMENT OR OTHERWISE. IF PURCHASER DOES NOT ACCEPT THESE TERMS OF HENRY'S LIMITED
WARRANTY, PURCHASER MAY RETURN WITHIN 30-DAYS OF PURCHASE ALL CONTAINERS OR PACKAGES OF
PRODUCT PURCHASED FOR A FULL REFUND (PROVIDED THE CONTAINERS OR PACKAGING IS UNOPENED AND LESS
SHIPPING CHARGES IF ANY). RETENTION OF PRODUCT BEYOND 30-DAYS FROM PURCHASE, OR USE OF PRODUCT
SHALL CONSTITUTE ACCEPTANCE OF HENRY'S LIMITED WARRANTY TERMS, CONDITIONS AND DISCLAIMERS. THIS
LIMITED WARRANTY PROVIDES THE PURCHASER'S EXCLUSIVE REMEDY FOR ANY DEFECT IN THE PRODUCT. To the
extent that any part of this LIMITED PRODUCT WARRANTY AND LIABILITY DISCLAIMER is determined unenforceable under the
law of the place of purchase of the product, that part is severed and the remainder of these terms remain in full force and effect. To
the extent permitted by law, the duration of any implied warranties is limited to the duration of Henry’s express warranty.
Savings Calculations: Based on a 1,200 sq. ft. house and retail prices as of March 2020.
For more information, visit www.henry.com or for technical assistance call us at 800-486-1278. For more information on the Henry® product warranty and liability
disclaimer please visit www.henry.com/warranty. Refer to the Safety Data Sheet prior to using this product. The Safety Data Sheet is available at www.henry.com or by
emailing Henry® Product Support at productsupport@henry.com or by calling 800-486-1278.
Henry is a registered trademark of Henry Company
The technical and application information herein is based on the present state of our best scientific and practical knowledge. As the information herein is of a general
nature, no assumption can be made as to a product’s suitability for a particular use or application and no warranty as to its accuracy, reliability or completeness either
expressed or implied is given other than those required by law. The user is responsible for checking the suitability of products for their intended use. Henry® Company
data sheets are updated on a regular basis; it is the user’s responsibility to obtain and to confirm the most recent version. Information contained in this data sheet may
change without notice.