Instructions / Assembly

Application
Apply the asphalt emulsion and cutback coatings at the uniform rate of 3 to 4 gallons/100 square feet by spray or brush
and immediately embed HE195 - POLYESTER FABRIC with 4" side and end laps or as specified. A long-handled paint
roller or soft-bristle push broom is recommended for pressing the fabric into the coating without wrinkles, or air pockets.
When dry enough for foot traffic apply a top coat of the same coating at 3 to 4 gallons/100 square feet. Refer to product
labels or data sheets for application details.
For maintenance treatment: Apply one or two layer fabric systems (with protective and reflective coating) directly over
existing smooth-surface roofs after making any necessary repairs.
For roofing and reroofing systems: Apply a coated base sheet (or heavy buffer sheet over gravel) mechanically
fastened or spot-adhered, then two layers of HE195 - POLYESTER FABRIC each embedded in, and top coated with,
any of the above protective coatings.
Polyester systems are not recommended directly over gravel or shingles. Surfaces to receive the fabric must be smooth.
Do not apply when air temperature is below 60ºF or if there is a threat of rain or temperature below 40ºF within 24 hours.
Caution
Product is combustible. Keep away from open flames. May cause mild skin irritation with prolonged exposure. Use
protective measures to avoid contact with eyes and skin. Wash with soap and water after use. In case of eye contact,
open eyelids wide and flush immediately with plenty of water for at least 15 minutes. In case of inhalation, remove the
person from the contaminated area to fresh air.
EMPLOYERS should obtain a copy of the Material Safety Data Sheet (MSDS) from your supplier or directly from Henry
at the toll free number or website below.
Product Sizes
6IN X 300FT ROLL (6 lb) 12IN X 300FT ROLL (16 lb) 40IN X 324FT ROLL (22 lb)
6FT X 324FT ROLL (50 lb) 10FT X 324FT ROLL (84 lb)
Limited Warranty
We, the manufacturer, warrant only that this product is free of defects, since many factors which affect the results
obtained from this product - such as weather, workmanship, equipment utilized and prior condition of the substrate - are
all beyond our control. We will replace at no charge any product proved to be defective within 12 months of purchase,
provided it has been applied in accordance with our written directions for uses we recommended as suitable for this
product. Proof of purchase must be provided. DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY: THIS
LIMITED WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT NOT
LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FOR A PARTICULAR PURPOSE.
MANUFACTURER SHALL HAVE NO LIABILITY OF ANY KIND BEYOND PRODUCT REPLACEMENT, INCLUDING
FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES RESULTING FROM ANY DEFECTS OR ANY DELAYS
CAUSED BY REPLACEMENT OR OTHERWISE. THIS LIMITED WARRANTY PROVIDES THE PURCHASER'S
EXCLUSIVE REMEDY FOR ANY DEFECT IN THE PRODUCT.
Henry Company 909 N. Sepulveda, Ste 650, El Segundo CA 90245-2754
Technical Services Phone: [phone] - Email: [e-mail]
The Henry Company is the parent company of Bakor, Inc.
www.henry.com
TECH HE195