User manual

6 Configuring with the programming assistant

rESEt

Error 2: Drive was removed during the configuration pro-

cess

The USB drive was removed during configuration. The process

is aborted. The counter must be restarted to reset any possible

errors in the configuration. This is shown by the message “rE-

SEt” on the display. Press any key on the counter to restart it.

In order to reconfigure the counter, remove the USB drive and

insert again.

rESEt

E3 XXX

Error 3: A configuration command has produced an error

message

A command error has occurred during configuration of the

counter, i.e., one of the commands in the configuration file re-

ported an error. The digits shown here as XXX (e.g., 014) refer to

the command error in the configuration file. It represents the

sequential number of the executed commands, not the row

number. Example: If error “14” is displayed, the error is con-

tained in the 14th command in the configuration file, irrespec-

tive of how many comments are noted.

USB

Abort

Configuration has been aborted

This message appears in the display if the configuration pro-

cess is not started within the specified time after finding the

configuration file, or if the process is manually aborted. The

display returns to standard view after a couple of seconds.

p1_tico_773_2773001_Betriebsanweisung_06062011_de_en.indb 18 02.02.2012 15:49:02