Installation Instructions

User Menu for DON2
1Scope
DON2 is a RF signal receiver which working at 2.4 GHz ISM band. RF signal will
be transfer to PC via USB after receive by DON2 from devices. DON2 is configured as
composite device on PC. RF signal from keyboard or mouse can be received by
DON2.
2ID for DON2
A unique ID number as the identification must be wrote into DON2 before using.
Keyboard or mouse using DON2 to communicate with PC must be wrote a identical
ID number too.
3Write ID
A unique ID number can be wrote into DON2 by a software which is run on PC
named as pairing manager. Connect a DON2 to PC via USB port first. And run
pairing manager to finish ID writing as guild by software.
There are two methods to write ID into keyboard or mouse. Option one,
connect keyboard(or mouse) to PC via USB and plug DON2 into PC at the same time.
Run pairing manager to finish ID writing as guild by software. Option two, connect
DON2 which ID number is set to PC, and hit hot key on keyboard or mouse to finish
ID pairing.
DON2 can be use now as ID number is set.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help

Summary of content (2 pages)