User's Manual
Table Of Contents
https://heltec.org
Documents Rev 0.1 P 6 / 6 Jun. 2021
Heltec Automation
©
Limited standard files
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to
provide reasonable protection against harmful interference in a
residential
installation. This equipment generates, uses and can radiate radio
frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or
television reception, which can be determined by
turning the equipment off and
on,
the user is encouraged to try to correct the
interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could
void the user’s authority to operate this
equipment. (Example-
use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject
to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that
may cause undesired operation.
FCC Radiation Exposure Statement:
The equipment complies with FCC
Radiation exposure limits set forth for
uncontrolled environment. This equipment should be installed and operated
with
minimum distance 20cm between the radiator and your body.
The device for operation in the band 5150–5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems.