User Manual

MMS
®
Inspection SPG High 9
Description
2.4.1 Gage concept
In order to measure, a batch (file) must be created in the gage for each appli-
cation. The calibration 001, which serves as a reference for each batch, is
saved in the gage. A description of the expression measuring application, and
the terms batch and calibration can be found in Chapter "Glossary".
The key contents of the batch files and calibration file and their relationship
with one another are shown schematically in the figure below:
A measuring application is defined in the gage by a batch file, which is always linked
with the calibration file calibration 001.
Measuring application
Batch 001
(settings)
• Limit monitoring
• Measured reading grouping
• Display value from i single
readings
• Measured reading view,
decimal places for the mea-
sured reading
• Unit of measurement
• Save measured readings
Calibration 001
(established through reference
measurement)
• Measurement on a glass sur-
face = Profile height 0
• 1 or 2 reference thicknesses
• Measurement in air = maxi-
mum recordable profile
height
Gage
Batch 002
(settings)
• Limit monitoring
• Measured reading grouping
• Display value from i single
readings
• Measured reading view,
decimal places for the mea-
sured reading
• Unit of measurement
• Save measured readings
Batch 003
(settings)
• Limit monitoring
• Measured reading grouping
• Display value from i single
readings
• Measured reading view,
decimal places for the mea-
sured reading
• Unit of measurement
• Save measured readings
(yes/no)