User guide

INSTALLATION INSTRUCTIONS

Rear Stabilizer Bar

92-99 (4X2&4X4) SUBURBAN

92-00 (4X2&4X4) TAHOE YUKON DENALI ESCALADE

(OLD BODY STYLE)

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

7608 ( R7608) 02/06/06

2 With Factory RSB

With Factory RSB Brackets

559-734-7451 800-367-5480 FAX 559-734-7460

End LinkAssembly

Bushing

Sleeve

9/16-18 Nut

Sleeve

Bushing

PAGE 1
559-734-7451 800-367-5480 FAX 559-734-7460 INSTALLATION INSTRUCTIONS Rear Stabilizer Bar 92-99 (4X2&4X4) SUBURBAN 92-00 (4X2&4X4) TAHOE YUKON DENALI ESCALADE (OLD BODY STYLE) Thank you for purchasing a quality Hellwig Product.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 4 Without Factory RSB Brackets 5 Without Factory RSB Brackets Vehicles w/o factory RSB brackets. Enlarge this hole using 1/2” Drill bit. This hole will be used to attach the clevis to the frame using the supplied 1/2” bolt, locknut, and washer. 6 Without Factory RSB Brackets TORQUE TABLE BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.
PAGE 3
559-734-7451 800-367-5480 FAX 559-734-7460 1. If equipped with a factory rear sway bar, remove the factory installed rear anti-sway bar and all of the mounting hardware . Do not discard the U-plate mounting bolts as they will be needed to install the new rear sway bar. Do not remove the frame bracket from the frame rail if equipped with a factory sway bar as it will be used to mount the new end links. 2. Choose the D-bushing that fits the u-plate for your application.