User guide

7268 ( R-7268) 11/19/2010

1 2 3

2 3 4

INSTALLATION INSTRUCTIONS

7268 Adjustable Rear Stabilizer Bar

1999-2010 2WD & 4WD F-250/F-350 Super Duty Except Dual Wheels

Thank you for purchasing a quality Hellwig Product.

3/4” ID Houglass

Bushings on frame

end.

5/8” ID Houglass

Bushings on sway

bar end.

9/16” Nut

PAGE 1
INSTALLATION INSTRUCTIONS 7268 Adjustable Rear Stabilizer Bar 1999-2010 2WD & 4WD F-250/F-350 Super Duty Except Dual Wheels Thank you for purchasing a quality Hellwig Product. 1 2 3 1 3/4” ID Houglass Bushings on frame end. 9/16” Nut 5/8” ID Houglass Bushings on sway bar end.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 TORQUE TABLE BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs. SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK THE WHEELS. NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST BAR, THE WEIGHT OF THE VEHICLE MUST BE ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE THE VEHICLE BY FRAME.
PAGE 3
559-734-7451 800-367-5480 FAX 559-734-7460 7. Attach the end links to the frame rail as shown in photos (4&5) using the 1/2 X 2 –1/2” bolt, washers and locknut. 8. Center sway bar on the differential and move the axle mounting hardware so the bar is aligned properly. Be sure to move any lines, wires or hoses on the axle or the inside of the frame to avoid any damage. Rotate bar up and down to make sure there is adequate clearance to all axle and undercarriage components as the suspension articulates.