User guide

ManualsBrandsHellwig ManualsCarSway Bar 6909

6909 (R-6909) 04/17/07

INSTALLATION INSTRUCTIONS

Rear Stabilizer Bar 6909

1964-70 Mopar B-Body

Thank you for purchasing a quality Hellwig Product.

559-734-7451 800-367-5480 FAX 559-734-7460

1970 models— Remove

breather and insert 1/8” thick

washer between brake tee and

axle as shown.

Summary of content (6 pages)

PAGE 1
559-734-7451 800-367-5480 FAX 559-734-7460 INSTALLATION INSTRUCTIONS Rear Stabilizer Bar 6909 1964-70 Mopar B-Body Thank you for purchasing a quality Hellwig Product. 1970 models— Remove breather and insert 1/8” thick washer between brake tee and axle as shown.
PAGE 2
559-734-7451 800-367-5480 FAX 559-734-7460 Spacer for brake line clearance 4 Driver’s Side shown 5 Bottom of sway bar arm to be even with bottom of subframe. TORQUE TABLE Bolt Size 3/8”— 35 ft lbs * Bolt Size 7/16”— 45 ft lbs* Bolt Size 1/2”—75 ft lbs *Bolt Size 9/16”— 90 ft lbs SAFETY: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE AND CHOCK THE WHEELS.
PAGE 3
559-734-7451 800-367-5480 FAX 559-734-7460 Remove undercoating where large washer contacts frame. Mark hole location and transfer to outer rail.. 6 7 8 4. Place the saddle brackets onto the U-Bolts on the axle tubes. Place the U-Plates over the D shaped bushings on the bar and attach the bar to the U-Bolts and saddle brackets with the flat washers and nuts provided. LEAVE LOOSE AT THIS TIME to allow for adjustment later. See PHOTO 3. 6.
PAGE 4
559-734-7451 800-367-5480 FAX 559-734-7460 Spacer tube must be 1/32” shorter than edge of large washer. 9 10 10a 15. Insert 7/16 X 6” bolt through driver’s side rail as shown in PHOTO 9. Insert 7/16 X 5” bolt in same manner through passenger side rail. Insert 2-3/4” long spacer sleeve into hole so that it is flush with the inboard wall of subframe. 16. For severe duty it is recommended that the spacer tube be welded to the outer subframe wall.
PAGE 5
59-734-7451 800-367-5480 FAX 559-734-7460 Attach end link to outer hole as shown before driving. DO NOT use inner holes until first driving vehicle with end link in outer position. 11 12 17. The spacer tube is extra long to allow for subframe variation and subframe repair caps. If spacer tube is not welded to outer wall, it must be fitted to the vehicle as described in step 18. 18. Review end link detail and install Large washer over spacer tube.
PAGE 6
559-734-7451 800-367-5480 FAX 559-734-7460 6909 (R-6909) 04/17/07