Owners manual

INSTALLATION INSTRUCTIONS

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

1904 ( R-1904 ) 10/6/2016

SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.

IMPORTANT NOTE: HELLWIG HELPER SPRINGS ARE DESIGNED TO INCREASE THE “LEVEL LOAD” CARRY-

ING CAPACITY OF YOUR VEHICLE. NEVER LOAD THE VEHICLE THAT THIS UNIT IS BEING INSTALLED ON BE-

YOND THE MANUFACTURER’S MAXIMUM GROSS VEHICLE WEIGHT RATING.

1 2

3 4

559-734-7451 800-367-5480 TechSupport@HellwigProducts.com

Crossbar under factory pack,

above factory overload

PAGE 1
559-734-7451 800-367-5480 TechSupport@HellwigProducts.com INSTALLATION INSTRUCTIONS Thank you for purchasing a quality Hellwig Product. PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION 1 3 2 4 Crossbar under factory pack, above factory overload SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES. IMPORTANT NOTE: HELLWIG HELPER SPRINGS ARE DESIGNED TO INCREASE THE “LEVEL LOAD” CARRYING CAPACITY OF YOUR VEHICLE.
PAGE 2
559-734-7451 800-367-5480 TechSupport@HellwigProducts.com 1. Be sure that the vehicle is on a flat, hard surface with the emergency brake on and the front wheels chocked. 2. Place the polyurethane block on top of the factory U-bolts and cast block on top of the Ford leaf pack as shown in Photo 1. 3. Place the Hellwig leaf spring on top of the polyurethane block so the block rests in the leaf’s center hump as shown in Photo 2. 4. Place the included 1/2” U-bolts in the cups of the spring on both sides.