User's Manual

Battery Change
Outline:
Battery Needed:
Battery Coin cell CR2025 (Link to where you buy)
Instructions for replacing Sleep Pill:
With the Hello logo faced up (facing you), pry up from the top edge
and pop the cap off
Remove the battery. Verify you have the right type of battery by
looking at the number on it.
Replace with new battery. Take your new battery and pop it back in.
The positive (+) sign should be right side up (facing out towards
you).
Place the white plate on top of your Sleep Pill making sure the
groves match. Slide one of the tabs into the open groove. When
that is aligned, visually align the other two tabs and snap down.
Once the battery is in, shake it a few times near the Sense and it
should be active. You will not have to re-sync.
[Video/Picture]
Final Content:
Battery Needed:
Coin cell battery CR2025(Link to where you buy)
Instructions for replacing Sleep Pill:
With the Hello logo facing towards you, pry up from the top edge
and pop the cap off.
Remove the battery.
Replace with new CR2025 battery. Pop the new battery back in with
the positive (+) sign facing out towards you.
Place the white plate on top of your Sleep Pill making sure the
groves match. Slide one of the tabs into the open groove. When
that is aligned, visually align the other two tabs and snap down.
Shake your Sleep Pill a few times near the Sense. Sense will flash
blue or red depending on what color your Sleep Pill was assigned.