Datasheet

3.7
354
Further information at www.HellermannTyton.com/protection
Date of issue: 10/2017
Cable Protection Systems
Wiring Ducts
MATERIAL
Polyvinylchloride (PVC)
Colour Grey (GY)
Length (L) 2 m
Operating Temperature -5 °C to +65 °C
Flammability UL94 V0
HelaDuct HTWD-PN wiring ducts are used to route and protect wires in
control panels and switching systems.
Features and benefits
Narrow slots suitable for small-diameter wires
Smooth, burr-free edges protect installers from injury and wires
from damage
Fingers can be removed with no sharp edges at pre-notched
snap-off points
Further pre-notched snap-off point at base of sidewall allow cutting
out and removing sections of sidewall with no sharp edges
Raised mounting points for easily and securely fastening wire
retainers and other accessores prior to cabling
Wire retainers and accessories leave no protruding parts below
surface of duct
Duct covers are easy to mount and remove, yet hold securely even in
a vertical position and under vibration
Cover is flush with side of duct, allowing for tight, contiguous
placement of ducts
Additional retainer nub on fingers on ducts height 80 and above to
prevent cables from slipping
Base perforation according to DIN EN 50085
Rigid PVC Wiring Ducts
HTWD-PN wiring ducts with narrow fingers and slots for small-diameter wires.
HelaDuct HTWD-PN for small-diameter wires
Width 25
25
48.5
25
100
Width 40-60
25
48.5
25
100
8
14
6.5
4.5
Hole
dimensions
For product specific approvals and specifications please refer to the Appendix.
HTWD-PN wiring ducts base perforation according to DIN EN 50085
25
48.5
25
50
100
Width 80-120

Summary of content (2 pages)