INFRARED INSTANT HEATER 2000W USER MANUAL Model Number: HIH20
BEFORE OPERATING THIS PRODUCT, READ, UNDERSTAND, AND FOLLOW THESE INSTRUCTIONS. Thank you for purchasing your new Heller heater. These operating instructions will help you use it properly and safely. We recommend that you spend some time reading this instruction manual in order for you fully understand all the operational features it offers.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. • • • The heater must not be located immediately below a socket-outlet. Regarding cleaning of the reflector, please refer to the relevant paragraph given below. Means for disconnection from the supply mains having a contact separation in all poles must be incorporated in the fixed wiring in accordance with the wiring rules.
2. Loosen the screw（M5*10) of the square part on the back of the unit. Fix the first 2 brackets onto the square part on the back of unit and tighten the M5*10 screw. Fix the distance from 45cm to 55cm between the two brackets. 3. Fix the other two brackets onto the wall according to the distance of the bracket on the back of the unit. Drilling a round hole with 8mm diameter on the wall, place two 4 plastic plugs supplied into the hole, using the ST4 * 35 screw to tighten the bracket onto the wall.
OPERATING INSTRUCTIONS Using the control panel on the unit: 1. Plug the mains plug into an earthed wall socket. 2. Press the power key and the blue indicator light on the touch screen icon will turn on . Display will not be on. 3. Press the one time，the blue indicator light remains, the display should show P0, the heater will be on standby. 4. Press the 2 times. The blue indicator light will change to red; display will show F1, the heater starts to work. 5. Same applies for settings 1 to 9.
Remote control instructions: 1. Press the on/off key, the display show “P0”. 2. Press 1 time for setting 1. The colour of this key on the touch screen will change from blue to red, display panel will show F1 and the total power consumption is 10%. 3. Press 4. will show F2. Same applies for settings 1 to setting 9. 5. Pressing the 6. Press key once. The power consumption is 50% of the total and the display will show P1. 7.
MAINTENANCE AND CLEANING ATTENTION: Careful and regular maintenance of this infrared heater is required to attain a long and efficient operation of your appliance. 1. Check the cleanliness of the reflector and IR-filament at least once a month. If necessary, apply cleaning and maintenance instructions. 2. The number of checks may be increased depending on the amount of the dust in the environment in which the heater is kept. 3.
