Operation Manual

Setting up the antenna
Version 1.2 - May 2008 HELLAS SAT Point&Play Setup Manual - page 22
Connecting the F-connectors on the coax cable
You will need a cutter (and possibly pliers) to connect the F-connectors. To connect an F-
connector to a cable:
1 For the outdoor end of the cable, first slide the rubber boots over the coax cable.
2 Strip the coax cable as shown below. Do not remove the aluminium foil or fold it back.
3 Fold the wire shielding backwards over the cable jacket.
4 Cut away the plastic shield. The result should look like the figure below (example showing the
indoor end of the cable).
outside use
1,4cm