Operation Manual

Setting up the antenna
Version 1.2 - May 2008 HELLAS SAT Point&Play Setup Manual - page 14
Step 3 - Mounting the antenna
1 Insert the 2 brackets in the masthead (as shown).
2 Use the 2 pole clamps and nuts to attach the masthead to the pole.
- If the pole is low enough, you can first assemble the masthead, brackets and clamps and
slide the assembly over the antenna pole.
- If the pole is too high or does not have an open ending, you will have to fix the masthead
around the pole.
- Do not attach the clamp too tightly as you will need to adjust it later on, but make sure the
clamp is attached tightly enough to prevent it from sliding down the pole.