Operation Manual

Introduction
HELLASSAT Point&Play Setup Manual - page 9 Version 1.2 - May 2008
Material you need to provide yourself
- A solid base for the antenna;
- An antenna pole;
- A Phillips head screwdriver PZ2;
- Open-end spanners of 10, 11 and 13mm;
- Tie-wraps;
-A cutter;
- A compass;
- A spirit level;
- A grounding cable;
This cable needs to meet the following specifications: UL style 1007/1569, PVC insulated, 300V,
80°C (C.S.A. Type TR-64) 18AWG, Yellow/Green attached to 4,3 mm insulation and 5,0 mm
non-insulation supported ring terminal.
- Geographical pointing data, available in the Antenna Pointing Information document.
Antenna pole requirements
- The antenna pole must be installed on a solid base and made of galvanized steel.
- Minimum diameter: 40 mm.
- Maximum diameter: 70 mm.
- The antenna pole needs to be grounded according to local regulations. Consult with a licensed
electrician if in any doubt.